top of page


Should Maintenance Technicians Own Their Own Tools?
I don't want to see a Leatherman taking apart a million-dollar machine. I don't want to see channel locks used where a wrench should be. I don't want to see an off-quality or under-rated meter on 480v. I don't want to see a hammer used instead of a mallet. I do want to see the right tool, of good quality and in good condition, taken out of an organized toolbox and used on the equipment. I want to see tools that won't damage the equipment or hurt my people. So here's my an

Mac Davis
4 min read


Electrical Preventive Maintenance: Tight, Cool, Dry, and Clean
Most electrical failures give you plenty of warning. But plants just aren’t looking. And they're usually easier to prevent than to troubleshoot or repair. A good electrical PM comes down to four words: tight, cool, dry, and clean. Tight. A loose connection adds resistance. Resistance under load makes heat, and the heat oxidizes the connection. Resistance climbs, makes more heat, and it feeds itself until something burns. I recommend checking every lug in each cabinet annually

Mac Davis
3 min read


When Operator Errors Become Maintenance Problems
When production calls maintenance to the machine, the problem becomes a maintenance problem. But when maintenance finds an operator-care failure or setup issue, there’s no button to send it back. That one-way handoff is a quiet incentive problem. Economists call it moral hazard: when someone else absorbs the cost of a failure, people take less care to prevent it. Look at who pays for what: → Prevention is small, visible, and paid by production. A wipe, a check, or adherence t

Mac Davis
1 min read
bottom of page
